If it still does then its probably a fault in the ribbon cables. You will have to disassemble the gimbal bit by bit until you find a fault and replace the faulty part. The cheapest and easiest thing to check, is the connection and ribbon cable between the drone and the gimbal board. You will need a 1.5mm hex screwdriver. Under the Shutter Button on the camera view, select “Format SD Card”. Then, format the microSD card in the app again. Sometimes, a microSD card formatted on other platforms may have a compatibility issue. The card may even not be identified. If the issue persists after formatting the microSD card, please contact DJI support. Jul 19, 2020. #2. Try rebooting the app and sign back in. I know p3 standard well, but not your model. Your problem on the p3s could be antenna or gimbal board. On p3s it still will fly without telemetry with bad antenna. On new gimbal all water stickers are white and not red. ( Camera and gimbal board) If you can, hook up a different RC. There is nothing you can replace, except perhaps the entire gimbal. It can be solved by an adjustment, but DJI do not reveal where that adjustment is. To cure it, it should be sent in for repair. Hi all,I am trying to fix a P4P that I purchased in a slightly beat up state. The issue I currently have is with the camera. Nov 17, 2013. #5. phantomman said: You need to bind the wireless range extender to the camera. I don't think it is the binding. I just turned on my Phantom with the range extender and transmitter turned off and with camera switch on Wi-Fi; the camera light was orange for a second and them went to green. • Easy-to-use mapping software developed to help you transform real-world scenarios into digital assets • Capture critical data, generate 2D and 3D maps, and perform detailed analyses – all on a single platform • Generate a 2D orthomosaic in real-time with real-time mapping • Use 3D Flight Visualization to design and simulate tasks on existing 3D models • Achieve rapid turnaround 83MlkI. I’ve used Drone Deploy for some years now flying mostly DJI Mavic’s but now got my hands on a Phantom 4 Pro. Kept using DD for land survey missions but have run into problems. Pictures are not focused - neither straight downs nor nadir ones taken during a 3D-mission. Comparing with similar photos taken with same drone from Go4-app shows a significant difference. Have been flying on 50 and I've just updated my Phantom 4 (original version) to the latest firmware using DJI Assistant 2 (which is also the latest version). All was fine before the update, but now, I do not get an image on my iPad Mini / iPhone 6 plus from the P4 camera when connected correctly to the controller/P4. Mostly I get just a grey image but every few minutes I Pixel 4 user here and the DJI stopped working after Android 12. Doesn't work after a reinstall either. The current app is incompatible with Android 12. DJI has been offering a beta app version for months that you can download from their site and sideload install on your Android 12 device. If the app is ready, why not submit it to the Google The Phantom 3 runs with the older version flight control app, so you should download the DJI Go app for your Phantom 3. If you’re flying a Phantom 4, you should download the DJI Go 4 app. The two apps are basically the same, but with a few upgrades to the latter. Both apps are available on Android and iOS. Phantom 3. Download DJI Go App for Reset the WiFi and rebind and see if that works.Page 25 and 26 of the manual. Make sure the cables are connected correctly (especially the 2 single wires). Then try to relink the RC and drone: I can use the remote control and move the gimbal up and down, but I haven't any picture on DJIGo on my iPhone.

dji phantom camera not working